Rejuvenate Floor Restorer

Product Information

First, give your floor a good cleaning. Move your furniture out-of-the-way if possible, and remove rugs. Clean the floor with a cleaner designed for use on hardwood floors. You want to make sure the floors are free of any dirt, grime and residue as this will help the revitalizer get into all the pores and light scratches. Let the floor dry completely before moving on to step two. Clean your mop periodically as you remove the Rejuvenate from your floors. Otherwise, the product will collect on the mop and undo your hard work. Don’t Soak Wood Floors If that doesn’t work, move on to one of the alternative methods: dish soap and water, vinegar, Windex, or ammonia. Some floor finishes can also yellow in UV light, so your floor can look a bit patchy in places simply because of where the light hits it during the day.

Next, squirt some of the product on the floor and use a soft cloth or mop to spread an even layer over your floor. Keep moving over the floor until the entire area is evenly covered. Polyurethane varnishes tend to yellow wood quite a bit, but it does depend on which one you buy. Polymer emulsion is designed to barely change the colour of wood at all, often appearing milky before it dries. And natural finishes can also yellow wood quite a lot, but this depends on the finish you use and the wood itself.

Rejuvenate Professional Wood Floor Restorer with Durable High Gloss Finish

It’s nontoxic and glides on with any cloth or mop action. There’s very little ventilation required, and it dries in only about 45 minutes. How Do I Apply It? We like this product for our wood floors because we don’t want to spend a lot of time resanding and refinishing hardwood. You’ll have to take that plunge eventually, but in between, you can extend the life of your floors with this short-term refinisher. It’s essential to restore your floors every so often to counteract wear and tear. Finished floors can look dull and dingy over time with foot traffic, pet nails, moving furniture, and other types of wear. Dirt and dust scratch the surface and the finish wears out over time. Despite the recommendation on Rejuvenate.com to avoid walking on your floors for only 45 minutes after applying the product, the representative said to wait overnight or at least 7 hours to allow the floors to dry completely. Use your mop to spread the revitalizer on the floor. Make sure it’s spread evenly to cover every corner. Don’t leave any puddles.

If you have oak floors, though, a polyurethane finish can be used to enhance the oak and make it look slightly less seasoned. Allow it to dry completely. Make sure no one has access to the room before it dries and that you have an exit strategy after application. You can see from our list of floor polishes that there are loads of different kinds. Some are polyurethane, some are polymer emulsions and some are natural oil and wax combinations. Note: Always read and follow the instructions on the label before applying Zep or any other cleaner to your floors. The steps can vary by brand and product. Alternative Method 1: Dish Soap and Warm Water

Final Thoughts

For example, the All Floors Restorer is designed for sealed surfaces, including laminate, hardwood, ceramic tile, marble, and linoleum that are at least five years old. It comes in an easy to use formula that doesn’t require mixing or diluting, so there’s nothing you have to think about first. You don’t even have to sand the floors down. It’s one of the easiest ways to give your floors a facelift. Rejuvenate’s professional formula helps restore shine and fill in small scratches from wear and tear. It bonds to your existing finish to restore shine and protect flooring. It’s not suitable for other types of flooring, but it does cover both residential and commercial hardwood. How Does It Work? No matter which brand of floor polish or restorer you use, always test it in a small, less visible area first, and let it dry completely before evaluating whether to use it on the rest of your flooring.