FixtheBog 20mm MDPE Outside Tap Kit With Plastic Wall Plate & Garden Hose Fitting DCV

Product Information

The tee needs to be connected to the cold water supply, typically under the kitchen sink on most outside tap installations. Pipe cut down and connected to water supply Once you’ve made it through with the small drill swap for the large bit and then re-drill the hole from the inside. Once about half way through, go outside and drill out the rest of the hole. As said, this will prevent the large drill bit blowing a huge chunk off the face of the outside wall. Step 4 – Fit Isolation Valve and Drain Plug Aside from the tap the next most important item is a water supply. When looking for a location to install your tap, it’s a good idea to select one next to or near an existing mains water supply pipe.

Outside Tap Kit With Plastic Wall Plate and Garden 25mm MDPE Outside Tap Kit With Plastic Wall Plate and Garden

Replacing an outside that has already been fitted is very easy and I would definitely recommend a DIYer to give it a go. To make sure you have a good supply of water to your water-butt connected system it is a good idea to collect water from any available sources such as gutters and down pipes from your house and any sheds you may have. Finally, cut another length of pipe so that it runs up to the hole through the wall. It should be around 10 – 15mm short of the hole to allow for a 90° bend to be fitted. A pipe clip also needs to be fitted along this section. However, the connection does not have to be made under the sink, as long as it’s a cold water supply at mains pressure, that’s all that’s needed. Don’t be tempted to feed an outside tap from water coming from a cold water tank as this will seriously affect cold water availability in the home.

Attach your outdoor tap

In this case, the water carrying pipe (e.g. the pipe running from the supply to the tap) should be allowed to expand and contract naturally through temperature change without fear of erosion or puncture due to it expanding and rubbing on the rough masonry. Cover the area with dust sheets and then pop the 8mm bit in the drill and position the tip on the drilling point and start drilling. Don’t force the drill bit into the surface too much, let the drill do the work. When drilling the hole try to angle it down towards the outside by 8 – 10mm or so. This will help prevent any water running in from the outside. There is usually a tangle of waste pipes and hot and cold water feed pipes under the sink which make connection of an outside tap difficult so in many cases it may be easier to look between the units, or even behind them to source a cold water feed to the outside tap which is a little easier to work with. Flexible and plastic hoses are more likely to leak, especially if there’s a tight bend in them, and might even burst open and flood your house one day.

Outside Tap Kits - Stevenson Plumbing Outside Tap Kits - Stevenson Plumbing

Then add a length of copper pipe to the elbow that you are using which should be connected to a tee (you should also fit an isolation valve if you can fit one on). The most common place is behind the kitchen sink, you can normally connect to the kitchen tap pipe. To prevent any such issues with your new garden tap it’s a good idea to trun the water off at the isolation valve and then drain the water out of the supply pipe through the drain plug.

pipe connectors (I used a T shaped Speedfit connector and two elbow connectors) and pipe inserts if you’re using plastic pipe