New Door Restore | Restore Colour and Appearance of Faded Composite uPVC Doors | 250ml

Product Information

One of the reasons that they are made with a composition of multiple materials is so that they can withstand the different abrasive weather that every door faces throughout a year. The most effective method for identifying and treating draught problems is to take a closer look at your door. You might be able to take fix it yourself with some care and attention, but in other cases, a professional will need to assist. All surfaces must be clean, dry and free of dirt, grease, grime and mildew. All waxes, polishes, silicone etc. should be completely and thoroughly removed. Treat any mildew with a 50:50 bleach and water solution. Scrub the solution on to the surface and allow it to stand for 10-15 minutes then rinse thoroughly. Using Polytrol on plastic, gelcoat, tiles, painted surfaces etc. It is definitely possible to replace a door without replacing the frame, as long as the door frame is in good shape and the new door panel is the exact same size as the previous one. However, there are some symptoms that may point to the necessity for a new door frame.

Additionally, ensuring sure the door is properly closed when you leave or enter your house may avert any further issues. Long-term problems can be avoided by 'throwing' the handle to make sure that the top part and bottom parts of the door are hooked in properly. Once you have finished using Polytrol, clean any brushes or other tools you may have used with white spirit. Cloths can be left flat to airdry before discarding. Buy your door from EYG and you don’t have to worry about a thing – thanks to our ten-year ‘repair or replace’ warranty promise. It’s important that your door is free from any dirt, grime, grease or mildew, so give it a good clean with some warm soapy water. Most exterior doors come with a built-in drainage system, using slots and holes in the bottom of the door’s threshold to ensure excess water runs off and stays outside your home.Applying the Polytrol to a wet surface will not produce the desired effect and could negatively impact the door. Polytrol works by saturating deep into the surface of the door, not by leaving a coating, so removal of the excess Polytrol is important. The best way to fix this issue is by adjusting the hinges on the door frame. Start by removing all existing screws from the hinges and then inserting new ones that are slightly longer. This will help create a tighter fit for the door and should stop any warping or bowing. You may also need to add additional weather stripping around the edges of the door if there are still gaps present after adjusting the hinges. Dropped hinges:

Simple to apply using a cloth or soft brush, it’s ready to wipe off in just 10 minutes! It can be used on both horizontal and vertical surfaces and can even be used on fibreglass (GRP). Polytrol dries to a tough and long-lasting flexible finish which does not leave a film – so it won’t peel or flake. If this isn’t done, the door will be resting solely on the latch, which has the potential to result in long-term problems, such as ‘warping or ‘swelling’. If the door is only lightly soiled, a simple wash with warm soapy water, a gentle scrub and thorough rinse might be all that is needed. Whether you need a primer, will depend on the type of paint you are going to use. Always follow the instructions.After this, it’s time to wipe off any excess product with a clean, lint-free cloth. Leave it to dry Rather than repainting the whole thing and making a mess, you could invest in a touch-up pen to fill in those grooves and scratches in the door. That includes removing any dirt from the surface of the door, cleaning around the frame, and even finishing the windows with a glass cleaner.

You then need to sand down the door all over as that will further help the paint to adhere. After you have sanded it, you then need to give it a thorough wipe down to remove the dust. Painting Once or twice a year, make sure the drainage holes are clear and remove all dirt. If necessary, use water to completely flush the drainage slots. Worn weather-sealsIf constant use does cause your hinges to drop, your door may need some minor hinge adjustment. Don’t worry, doing this from time to time is natural.