Joined in 2023 
82 
63 About this deal
Dip your finger in soapy water or use a specialized silicone tool to smooth and shape the sealant. This will create a neat finish and ensure a watertight seal. Be sure to remove the masking tape immediately after smoothing each section to avoid creating jagged edges. We know that not everyone has the luxury of a freestanding bath and that many modern bathroom designs will incorporate over-bath showers that also require sealing. When sealing a bath, follow the preparation advice above but remember that there is one crucial extra step you will need to take before reaching for the silicone sealant. Step 2: Cut an access hatch in your floorboards next to the shower tray so that you can easily access the underneath of the shower tray for maintenance to the pipes. Whether it’s part of a bathroom makeover or you need to replace an old and damaged shower, knowing how to seal a shower tray is essential. And while it may sound like a daunting task, with a little care and patience, it’s a relatively simple project too.
Mask off the areas surrounding the shower tray with masking tape to protect them from accidental sealant application. This step will also help you achieve clean, straight lines when applying the new sealant. Byretech's Shower Seals are gloss white and are easily cut to size. We profile one end to make fitting extremely simple and even the sealant is included in the kit too. Remove loose deposits and surface dust with a vacuum then, with a damp cloth that has been soaked in a mixture of warm water and mild detergent to remove any stubborn deposits, thoroughly clean and dry the area where the silicone sealant will be applied (the shower tray surface and tiles). Please note that although these instructions are comprehensive we always recommend that a technically competent installer undertakes the installation. Once you’ve removed most of the sealant from the surface you’ll be left with at least some small strands. Use either your finger or thumb to rub it off or you can use white spirit – simply dab a little on an old cloth and rub over the excess strands until they come off or dissolve.Using a small roller or other appropriate tool roll the seal strip so that it attaches firmly to the edge of the tray removing any bubbles or creases paying particular attention to the corners. Remove old sealant – Use a sealant remover to dissolve the existing sealant, or, carefully scrape at it with a plastic or metal blade. In conclusion, sealing a shower tray is a crucial maintenance task that can help prevent water damage and keep your bathroom in excellent condition. By following these steps on how to apply shower tray sealant, how to silicone a shower tray, and how to remove old sealant from a shower tray, you can ensure a watertight seal that will protect your bathroom for years to come. Regular maintenance and inspections will help you catch any issues early and prevent costly repairs down the line. Step 5 - Use a spirit level to ensure that the tray is completely level the whole way around. This is one of the most important steps in installing a shower tray as a tray that isn’t level will cause issues with drainage and water could gather on one side of the tray and potentially overflow. Trays are designed so that the water runs towards the waste outlet, so there’s no need to tilt the tray.
The water in the bath acts as a weight (most baths settle slightly when filled due to the movement in flooring) and ensures that the silicone sealant will not stretch or tear when the tub is filled at bath time and the weight of a human is added.
Trimlux Professional 25 (mm)
Place the smoothing tool against the tray and tiles, start from the point where you first applied the sealant and apply gentle yet consistent pressure pulling the tool along the length of the tray to remove excess sealant leaving an even bead. Buy a good retractable utility knife. A sharp knife will be required for opening the silicone sealant and trimming the application nozzle to size.
Great Deal 
New Comment