Ubiquiti Wireless Dual-Band Gigabit Access Point, UAP-FLEXHD

Product Information

Please note: If you are mounting the UAP-FlexHD outdoors, it must be installed in the upright position, with the Ubiquiti logo facing up, to prevent water from getting into the base of the device. Indicates the device is in an isolated state (all WLANs are brought down until an uplink is found). Desktop The UAP FlexHD stands freely on a horizontal surface such as a desktop or table/shelf. Good for temporary installations.

Configure custom settings, including authentication, Hotspot setup, and the option to use your own external portal server. 802.11ac MU-MIMO technology Note: If you are mounting the UAP-FlexHD outdoors, it must be installed in the upright position to prevent water from getting into the base of the device. Wave 2 MU-MIMO (Multi-User, Multiple Input, Multiple Output) technology allows a Wave 2 AP, such as the UniFi AP Flex HD, to communicate with multiple clients at the same time – significantly increasing multi-user throughput and overall user experience. The following describes a 4-client scenario: Both Wave 1 and Wave 2 APs offer 28 independent (non-overlapping) channels: three for the 2.4 GHz band and twenty-five for the 5 GHz band, including DFS channels. When you use the 2.4 GHz band in a high-density location, you encounter self-interference and channel saturation. When you use the 5 GHz band, you can deploy smaller cells (coverage areas), so you can support more clients in any cell that deploys more than one AP. We require this information to understand your needs and provide you with a better service, and in particular for the following reasons:Note: When installing Ethernet cabling on a pole or up the outer surface of a wall, use RJ45 connectors without strain-relief boots on them. This will prevent unnecessary tension on the cable ends. Best mesh Wi-Fi 2021: banish dead spots and boost your broadband How to boost your business Wi-Fi Ubiquiti Networks UniFi nanoHD review: Software-defined networking on a budget Upgrade your wireless APs Zyxel Multy Plus review: SMB-friendly mesh Wi-Fi A 4x4 Wave 2 AP delivers up to 33% greater performance than a Wave 1 AP that is 3x3 in both radio bands. With the advantages of MU-MIMO technology and 4x4 spatial streams, the UniFi AP Flex HD can support more than triple the number of users than a typical Wave 1 AP. In practice, the maximum number of users the UniFi AP Flex HD can support is limited by radio link airtime. This depends on the amount of traffic each device creates, types of devices, network configuration, and the presence of other APs on the same channel. Versatile Mounting Options

Create multiple LAN and WLAN groups and assign them to the respective UniFi devices and VLAN tags. Predictive maps Initial 802.11ac Wave 1 SU-MIMO (Single-User, Multiple Input, Multiple Output) technology allows an earlier-generation AP, such as the UniFi AC Pro AP, to communicate with only one client at a time. 802.11ac Wave 2 MU-MIMO (Multi-User, Multiple Input, Multiple Output) technology allows a Wave 2 AP, such as the UAP-FlexHD, to communicate with multiple clients at the same time – significantly increasing multi-user throughput and overall user experience. The following describes a 4-client scenario:

Upload a map or use Google Maps to represent the areas where your UniFi devices are located. Use the predictive map feature to get a preview of coverage and to help you avoid dead spots (available version 5.6 or higher). Wireless Uplink MU-MIMO: Assuming the same conditions, a Wave 2 AP provides up to 75% improvement overall over a Wave 1 AP. This improvement increases wireless performance and/or serves more clients at the same performance level.